Information Clean out airways/end of the program

Clean the lint filters.

To remove the plinth filter, press the round, indented area on the heat exchanger access panel to open it; see Fig. 1.

Pull the plinth filter out by the handle; see Fig. 2.

Pull the handle out of the plinth filter; see Fig. 3.

Clean the plinth filter thoroughly under running water.

Squeeze the water thoroughly out of the plinth filter.

The plinth filter must not be reinserted while it is dripping wet. This can cause a fault.

Use a damp cloth to remove any lint from the handle.

Insert the plinth filter back on the handle, making sure it is the correct way round; see Fig. 3.

First insert the handle with the plinth filter attached over the two guide pins:

The word Miele on the handle must be the correct way up.

Push the plinth filter in completely.

The act of pushing in the plinth filter will also push in the right-hand guide pin.

Close the heat exchanger access panel.

The tumble dryer can only be operated with the plinth filter installed correctly and the heat exchanger access panel closed. The access panel must be closed correctly to ensure that water cannot leak from the condenser system and to ensure that the tumble dryer functions efficiently.

Touch the OK sensor control to confirm and clear the message.

The fault message will no longer be displayed.

If too much detergent has been used when washing, white residue may be encrusted on the edges and front of the plinth filter, see Fig. 4.

Wash the plinth filter on its own in the washing machine without any detergent at a max. temperature of 105°F (40°C) at a spin speed of 600 rpm.

If the plinth filter has not been cleaned properly or is very old, the filter may become deformed or tear, see Fig. 5. The plinth filter no longer sits flush. Lint will get into the heat exchanger without being filtered out.

Replace the plinth filter.

Plinth filters are available from the Miele online shop.