The faucet is not open.
Terminate the wash program.
Turn on the faucet.
Select the program and start it again.
Support for yourWasher
Hot water inlet fault
Hot water inlet fault appears in the display of the washing machine/washer-dryer. The water inlet is blocked or restricted.
The inlet filter is soiled.
Clean the inlet filter:
Turn off the faucet.
Unscrew the water inlet hose from the faucet.
Remove the rubber seal (1) from the recess.
Hold the free end of the water inlet hose upside down. The plastic filter (2) will fall out.
Clean the inlet filter.
The inlet filter must be put back in place after cleaning.
Re-assemble in reverse order.
Turn on the faucet and check that the connection is watertight.
If water drips out, tighten the connection.
The water inlet hose is kinked.
Remove any kinks or loops from the water inlet hose.
Monitor these points for a while afterwards, as the plastic may weaken and tear. In the event of any damage, the water inlet hose must be replaced. Please contact Miele Service.
The water connection pressure in the water line is too low.
Contact the facility manager or a plumber.
The water connection pressure in the water line is too low and cannot be increased.
Please contact Miele Customer Service.
Manual finder
Here you will find the operating instructions for your Miele appliances.
Find your manual
Support 24/7
Use our contact form to describe your request. Miele Service will get back to you as soon as possible.
Contact us